The Maximus Formula Thread - Help/OCing/Guide/Rampage conversion

[Grnfinger]

Nothing on hwo to help my little problem or if could someone help me work out what on earth my RAM is trying to do? (it's possibly the problem)

~Bex

Post your complete bios setup.
Test your ram @ stock with memtest
Once you can rule out bad sticks we can tweak the bios from there

Someone help me with what I mentioned 5 postings up.

Please

pull 1 card then the other to make sure they both work, you could havea defective card
Make sure you have the 6 pin connectors on BOTH cards.
Other than that reinstall the drivers

[RCG_Bex]

Post your complete bios setup.
Test your ram @ stock with memtest
Once you can rule out bad sticks we can tweak the bios from there

I posted previously - and it's not a bad stick - I meant I don't know what it's running at because if I tell it to run at a certain speed it doesn't boot but if I leave it on Auto it boots fine.

Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : AUTO
CPU Ratio Control : Manual
- Ratio CMOS Setting : 8
FSB Frequency : 500 (510, 515 and 525 have been attempted)
FSB Strap to North Bridge : Auto
PCI-E Frequency: 100

DRAM Frequency: Auto
DRAM Command Rate : Auto
DRAM Timing Control: Auto

CPU Voltage : 1.5875v (1.6 has been tried)
CPU PLL Voltage : 1.50
North Bridge Voltage : 1.47
DRAM Voltage : 2.14
FSB Termination Voltage : 1.42
South Bridge Voltage : 1.075
Loadline Calibration : Enabled
CPU GTL Reference : 0.63X
North Bridge GTL Reference : 0.67X
DDR2 Channel A REF Voltage : Auto
DDR2 Channel B REF Voltage : Auto
DDR2 Controller REF Voltage : Auto
SB 1.5V Voltage : 1.55

CPU Spread Spectrum : Disabled
PCIE Spread Spectrum : Disabled

The RAM is Adata Extreme 1200

~Bex