so is the method of using the special vid just as good as the normal way?? or should i rma this mobo it works fine with a q6600 and a e2180? but so far afte 2 e8500's and a e8400 i cant go over the 1.21xx volt settings without using the special vid?? so is it the 45nm or a bad mobo?? i have now at 1.26 at the same overclock and stable with prime and orthos.. so yeah this sems to be a really nice cpu and temps are now just about 58-61 with 1.26 @ 4.012.
one of the temp sensors reads 10deg higher than the other though now till they both get to mid 50's then they are pretty similar?? ive tried 2 heatsinks with the same results and checked the heat spreader with a razor and its pretty flat?? so do you think bad sensor on one core??
Reply With Quote
Bookmarks