**Official ASUS Striker II Formula Discussion/Review/Overclock/Guide/BIOS Thread**

[EvoCarlos]

I'm using the following volt settings:

vcore: 1.33750V (1.31 actual), Loadline Cal off
pll: 1.52V
vtt: 1.28V
nb: 1.4V
sb: 1.5V
vdimm: 2.10V (using OCZ 2X2GB CL4 RAM@4-4-4-12-2T)

The rest is all at auto. They work great with 0902.
FSB is 1600Mhz with memory linked in sync mode.

see this post i put up for someone else the mobo is running @1600mhz on 1305bios HERE
the cpu is diffrent but i think the setting should be the same its only you can change your multplier to any random one lol
i think from the volt settings in the images i only had to set the sb 1.5v to get it 100% stable but the load cal is needed. also i think the gtl setting is a glitch with the mobo lol but it helps

[Amuro]

see this post i put up for someone else the mobo is running @1600mhz on 1305bios HERE
the cpu is diffrent but i think the setting should be the same its only you can change your multplier to any random one lol
i think from the volt settings in the images i only had to set the sb 1.5v to get it 100% stable but the load cal is needed. also i think the gtl setting is a glitch with the mobo lol but it helps

Thanks I'll try that later. Maybe it's the loadline cal which needs to be on, but I always had it off.

What is your highest stable settings on a QX9650 ?

I'm not sure. I've never tried to push mine higher than 4.0 as I want to stay below Intel's max VID of 1.3625V.