ATI 4850/4870 voltmod thread

[rym]

ok, the spot is somewhat like a mushroom , the head being the part you see
[a dot]. that part came off leaving the stock of the trace going to where it goes on the other side. Actuallythe dot its a hole going through the card to the other side connecting to a pin on an blacksquare thingy.
[ controls voltage i think]so the the head gone, leaving a smaller dot. to small to solder to. the trace still works fine.. so does the card. I hope you under stand . I can draw a picture if your brains arent working .. just kidding..


surface before ----- after -