Quick question - Acrylic

[Locksley]

Yes, I can concur with the sticky that the S-1200 is not very good in a restrictive environment. Apparently Noctua acknowledge this too.

Now the NF-P12 is an other story; it got great reviews in close fitting environments, it's close fitting nine bladed fan is both quiet and effective at pulling air even though it's showed up right against a grill or rad. So this is what I'll do, go with the P12 and eventually (when I've set up the loop) post some subjective results.

On an other note - I've found (with the help of the sticky with shops) an other store that has a nice selection. The www.watercoolingshop.com. The other one I had been looking at was a German one that is not in the sticky http://www.caseking.de

I am going to miss Aseteks temp readings and fan control and such but gain better pressure but less flow rate with the Laing.

And the UK shop got dtek (but out of stock, neither does it say if it's v2), going to use the quad spreader - good idea?

Seems my shopping list changes every few days lol.

Any thoughts on using Waterwetter - good idea or keep away?

[Kayin]

Keep away. Not only is it toxic, but it messes with temps more than pentosin and it really doesn't do much for a rig at the temps we operate at.

[IanY]

Run away from it. It stinks to high heaven. Its nasty and slimey.

[bigslappy]

Any thoughts on using Waterwetter - good idea or keep away?

distilled water is the best & cheapest cooling liquid there is & being the best non-conductive liquid u can use
It's a no brainer !

UV is bad on alot things plastic & it's bad for your eyes causes cateracts on yer eye lenzes
Think exposing yer systems to full sun & how bad that will do to all things plastic