**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[JGKC9AYC]

Well, I got my UT P35 installed in my case & everything hooked up. I hit the power button, it ran for about 3 seconds, shut off, restarted, ran for about 2 seconds, shut off, etc. No post, didn't even run long enough to turn the power LED on my monitor from amber (standby) to green (power).
I reset everything I could reset, reseated everything that could be reseated, but still no go.
I know the ram & the video card that are in there are good as they just came off my previous motherboard.
Ideas? Suggestions?
Thanks.

[Praz]

Well, I got my UT P35 installed in my case & everything hooked up. I hit the power button, it ran for about 3 seconds, shut off, restarted, ran for about 2 seconds, shut off, etc. No post, didn't even run long enough to turn the power LED on my monitor from amber (standby) to green (power).
I reset everything I could reset, reseated everything that could be reseated, but still no go.
I know the ram & the video card that are in there are good as they just came off my previous motherboard.
Ideas? Suggestions?
Thanks.

OK...I just got one of these & have a question (since I don't really have time to go through 189 pages...please forgive my laziness).

As you listed none of your components it's doubtful anyone can give a definitive answer. Sounds like it could be a common issue that's easy enough to solve though. The answer is in this thread. Too bad you really didn't have time to go through it.

[Jupiler]

Try reseating your cpu.
I had the same thing happen a couple of weeks ago after swapping cpu's (from E8400 to X3350).
Reinstalled the E8400 and all went fine.

Be sure to clear CMOS (both the blue and red jumper) before installing your cpu.

[JGKC9AYC]

As you listed none of your components it's doubtful anyone can give a definitive answer. Sounds like it could be a common issue that's easy enough to solve though. The answer is in this thread. Too bad you really didn't have time to go through it.

Intel E6300 w/Xigmatek HDT-S1283, XFX 7900GT, 2x1GB Corsair XMS DDR2-800, 2xSamsung SH-S203B, WD 640GB hdd, Corsair 520HX.
You're right...it really is too bad I don't have time to go through 190 pages, but working 2 jobs 6 days a week will do that to a person.

[doakh]

I reset everything I could reset, reseated everything that could be reseated, but still no go.
I know the ram & the video card that are in there are good as they just came off my previous motherboard.
Ideas? Suggestions?
Thanks.

Just because your ram worked in another motherboard does not mean it will automatically work in this one.

[JGKC9AYC]

Just because your ram worked in another motherboard does not mean it will automatically work in this one.

Perhaps, but it is on the DFI "approved" list for this motherboard.
Corsair XMS DDR2-800 2x1GB.