**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[mrcape]

you will have no problems at all. Just curious however, are you flashing back from 502 or 521? If so, any reason why?

From 5/21. Not sure if there's a major difference, but I want to go back and be sure, and take note of it.

5/21 is working just fine with all of my hardware and cmos profiles. The one thing I did notice (and want to confirm) was that 3/17 applied .02 less vcore at idle in windows, for the same amount set in bios (same profile). Not that that's a big deal at all, it seems to be that a range shifted slightly is all. In other words, with 5/21 I had to adjust down a few bumps to get the same idle vcore I got in 3/17.

Also I sorta jumbled the 5/21 I'm currently running testing high fsb. I got some scrambled cmos codes, reset, got em again, reset, boot up fine. I know I need to reflash something, so now is a goot time to check 3/17 again.

[cantankerous]

From 5/21. Not sure if there's a major difference, but I want to go back and be sure, and take note of it.

5/21 is working just fine with all of my hardware and cmos profiles. The one thing I did notice (and want to confirm) was that 3/17 applied .02 less vcore at idle in windows, for the same amount set in bios (same profile). Not that that's a big deal at all, it seems to be that a range shifted slightly is all. In other words, with 5/21 I had to adjust down a few bumps to get the same idle vcore I got in 3/17.

Also I sorta jumbled the 5/21 I'm currently running testing high fsb. I got some scrambled cmos codes, reset, got em again, reset, boot up fine. I know I need to reflash something, so now is a goot time to check 3/17 again.

Thanks for the explanation. I was thinking of going to 5/21 so wanted to hear your opinion on it. When it comes to the slightly higher vcore, was vcore set it in bios itself, or did you have vcore on auto but adjusted using the special % option?

[mrcape]

Thanks for the explanation. I was thinking of going to 5/21 so wanted to hear your opinion on it. When it comes to the slightly higher vcore, was vcore set it in bios itself, or did you have vcore on auto but adjusted using the special % option?

The vcore was set manually with no special add. And yes vcore amount manually set in 3/17 definitely applies less voltage by .02v.

So it was all a success. Thanks for confirmation that rolling back works. I've had a Brother Esau bios chip on hand for months and had no need to use it yet. I have OC'd the crap out of it hundreds of different ways and was sure by now I'd fry that chip. This board is a just a tank!