What do you mean good spread? i followed the directions i put a medium strip east-west in the middle of the chip, i did use a latex glove and my ringer to spread it out a bit so it would cover all the cores, is that good? (i don't plan on lapping either my HSF or the CPU, will i be okay?)

Also i ran prime last night and i work up this morning it was still going but right as i popped out of the shower BOSD and a reboot the voltages were 1.44 and i not comfortable going anything higher especially with a board where the only way i can control the vcore is by "special add" only. -i keep kicking my self fro not getting the LT.

i dropped the FBS to 360 with a 1.28+.125= sitting at 1.36-1.376 maybe ill have luck with this setup.