Catch can you correct me if I'm wrong. I'm trying to put this all together, and I'm kinda confused with all the revisions.

Do you remove MC50 or leave it and solder to it?


1. remove resistor mc64
2. cut the trace on the back of mobo

3. remove mc50 or leave mc50??????????

4.Alternate way is to use 1 vario. Try a 1k vario 20-25 turn cerment pot. set resistance between middle pin and one of the outer pins to 200 ohms. Connect middle pin to left pad of mc 50 after removing mc50. Connect the pin you set for 200 ohms to mosfet located upper right corner of mobo. The lower leg of that mosfet. Connect other pin to ground. Pic kinda shows what i mean.