The Maximus Formula Thread - Help/OCing/Guide/Rampage conversion

[XtremeTiramisu]

Try These:

Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : AUTO
CPU Ratio Control : Manual
- Ratio CMOS Setting :9
FSB Frequency : 400
FSB Strap to North Bridge : 333
PCI-E Frequency: 100
DRAM Frequency:
DRAM Command Rate : 2N
DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 15
RAS# to RAS# Delay : auto
Row Refresh Cycle Time : auto
Write Recovery Time : auto
Read to Precharge Time : auto

Read to Write Delay (S/D) : auto
Write to Read Delay (S) : auto
Write to Read Delay (D) :auto
Read to Read Delay (S) : auto
Read to Read Delay (D) : auto
Write to Write Delay (S) : auto
Write to Write Delay (D) : DRAM Static Read Control:disabled
Ai Clock Twister : auto
Transaction Booster :disabled

CPU Voltage : 1.4v and onwards
CPU PLL Voltage : auto
North Bridge Voltage : 1.51v and onwards
DRAM Voltage : 1.90 depends on your ram. mobo overvolts by 0.8v
FSB Termination Voltage : 1.40
South Bridge Voltage : 1.050
Loadline Calibration : Enabled
CPU GTL Reference : 0.63
North Bridge GTL Reference : 0.67
DDR2 Channel A REF Voltage : AUTO
DDR2 Channel B REF Voltage : AUTO
DDR2 Controller REF Voltage : DDR2-REF
SB 1.5V Voltage : 1.5v

NB LED Selection : NB Volt
SB LED Selection : SB Volt
CPU LED Selection : CPU VOlt
Voltiminder LED :

CPU Spread Spectrum : Disabled
PCIE Spread Spectrum : Disabled

Advanced CPU Configuration
CPU Ratio Control : Manual
- Ratio CMOS Setting :
C1E Suppport : Disabled
CPU TM Function : Disabled
Vanderpool Technology : Disabled
Execute Disable Bit : Disabled
Max CPUID Value Limit : Disabled


USB Configuration
USB Functions: Enabled

Good luck,
XT

[Ric2L]

Try These:



Good luck,
XT

Thank You, started with your suggested settings, ran prime for 2 hrs, everything good. bumped vcore & n/b volt down two notches, so far so good, will let prime overnight, maybe lower a little more if still stable.

would be nice to get ram back to 1066 or better, with 333 strap only have option of 960 or 1280, running at 960 now, 1280 is to much for my ram I think, will have to play with it after I'm sure that I'm stable at lowest possible voltages

[Sources]

Thank You, started with your suggested settings, ran prime for 2 hrs, everything good. bumped vcore & n/b volt down two notches, so far so good, will let prime overnight, maybe lower a little more if still stable.

would be nice to get ram back to 1066 or better, with 333 strap only have option of 960 or 1280, running at 960 now, 1280 is to much for my ram I think, will have to play with it after I'm sure that I'm stable at lowest possible voltages

I use the 400 strap to get 1066mhz