...Whoops?

I was trying to figgure out why the voltages were jumping around soo much, and noticed i somehow put in a 20K trimmer on the GPU... Yea, it was hard to get what voltage i wanted. You think 1k is bad >1.35V? try 20k. Anyways, i dug up a 500 ohm 20 turn... MUCH MUCH better.

It appears that additional voltage is a problem if your not using it. My card is stable at 850/1200 if i give the gpu 1.46V under load. If i run 1.47 into it, it locks after a few mins, 1.48 and its even faster...

So, it would appear one shouldnt just crank up the voltage and see how high you can get it...