OK, I just got done putting a new cooler on my DFI, so while it was out I took measurements. The mounting holes appear to be 77mm apart (center to center), and entire backplate looks like it should be around 87mm long. The top end has only about 5-7mm of clearance before it hits the motherboard mounting hole right above that.
Yes you are right. Just measured mine as well.Originally Posted by t_ski
The backplate has to be at least 80 to 85mm but I could not find any already made with that size so a good plate would be this 107mm from Koolance:
http://www.koolance.com/water-coolin...product_id=659
And then each would trim and punch holes if needed.
I would guess the Ek Mosfet Backplate would do also (but I don't have their exact measurement) and they are sold out everywhere.
//RETIRED-o00o--°(_)°--o00o-OVERCLOCKER//
Posting Permissions
Reply With Quote
Bookmarks