Another WaterFall Reservoir

[fart_plume]

Oh, great so they are out to get me..............better ammo up then ...........
Where are those beans and raisins?

[[XC] NetburstXE]

Just because you are not paranoid does not mean they are not out to get you....^^

I am keen to get that rolling. It's just been a week for maintenance and then I got this wild hair to start the cooler...it's still sitting there hogging the bench...so I will put it aside and move on to the reservoir assembly.

I got a real camera that takes movies longer than 30 seconds and with a much higher resolution so I'll see if I can make a quick acrylic fusing tutorial..nothing much to it...but it might be interesting to know exactly how it's done.

I'd be interested in an acrylic fusing tutorial.

[CyberDruid]

You got it. I'll dig out the tripod.

[fart_plume]

Tripod for which the the guns or the camera?

[CyberDruid]

AR gets the Bipod; Nikon gets the tripod

[fart_plume]

OH, OK just thought I'd better get a clarification there,lol

[Crankyhobo]

I'd be interested in an acrylic fusing tutorial.

I too would like to see it.

I have been thinking about making a custom res maybe a large (3-5" ID) plexiglass tube as the base just need to figure out a way to plug the ends and put fittings on.

http://www.eplastics.com/Plastic/Ple...s_Acrylic_Tube

[DarthBeavis]

I have 18 extra feet of this


4" OD, 3.75" ID . . .though it costs $15/foot

[Kennymester]

Here's how the last one turned out.

[Pedalmonkey]

looks good.

[Jimmer411]

It would be interesting to see one of these that extended down the front of a Stacker 810 or similar multi bay case.maybe had a 3x5 1/4 chute that the water falls and then pools into a section at the bottom where the pump inlet is located. Use CCFL to light it from behind possibly.

[CyberDruid]

The possibililties are endless really. I am going to make some for side panel windows...

[fusionmkx]

Possible to have a acrylic-cutting/gluing tutorial? Really love your work man! =)

[CyberDruid]

I sorta kinda have some vids on that in YouTube (CyberDruidtheModGod) but I havce not taken the time to do a step by step cosumentary.

I did make a vid the other night while gluing up more reserrvoirs but Youtube wouldn't upload it...kept timing out.

I will see what I can do.

[SafeFire]

BUMP.

Just looking through the worklog again, I can't stop drooling at the pictures of it with water.
Anyway, how thick is the acrylic? I'm sitting here drawing one up in 3d myself, completely out of boredom, and I'd like to be able to do draw it with Acrylic thickness included.
The point of the story is to attempt a model divided up into three vertical chambers, see how that turns out, if anything in 3d