Innovation Cooling's Diamond 7 TIM test results

[littleowl]

Like I said we tend to do better against the 1+ month cured pastes and about 3C against the fresh install comparisons which is pretty close to what I get on a bench test @ 100W obviously if you are running 150W the delta would be higher around 5 C and 50W 1-2 C.

There are some very competitive performance pastes out there but I do not expect them to really test any better performance wise I had one formulation of our grease that had performance of 10WmK and was only .5C better @ 100 W Plus when you measure the resistance across the compound with thermocouple in-sink and in-die the temp drop was only 1.1-1.2 C @ 100W - Not much left to improve upon except the reliability/longevity

On the initial completed giveaways the averages have not changed much since the initial sample of around 30. Averaging is great stuff and the data suggests solutions like application amount, methods for optimization, trouble shooting etc.

You guys (this group )have given me a good education of the current state of the art on mounting hardware and several potential options for refining our message and trouble shooting guide. You are prime candidates for doing a similar beta test on our upcoming Thermosyphon. Good stuff, thanks

I am also interested. can you tell us more?

[D_A]

Yes, please do. Though I suppose we should start a new thread for it, to be consistent.

[tastymannatees]

I am also interested. can you tell us more?

Off and on again project. Advantages are cost and size, we might make a few units for the performance market but that's not the target, performance as good as any tower and that's about it and all I can say at this point. This group with a beta test would be a good way to work out any kinks as you guys are the TIM and sink experts.

I also got the 24 carat tubes today and should be available by the end of the week.