**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[sammurai]

My board is DFI LT P35-T2R last BIOS version.
My ram: TXDD2048M800HC4DC Micron D9

This ram work at 536mhz@4-4-3-3-1 with 2.45v set in BIOS


562mhz@4-4-4-4 with same voltaj


but don`t work to 600mhz@4-4-4-x not even with 2,65V set in BIOS.

I tried 400*9 with 266/800 and 375*8 with 333/1066 but the system freeze to dfi logo.

DDR Voltaj 2,65v
SB 1.05v 1,15v
SB Core/PLL 1,75v
NB 1,5v-1,57v
CPU VTT 1,4v

FAST
FAST
DISABLE
4
4
4
12
AUTO (rest of the setings).

Do you have any sugestions?

[mad_skills]

If you care to read this review of the board:
http://www.anandtech.com/mb/showdoc.aspx?i=3129&p=1
you'll find that some straps work better with memory overclocking rather well while other give not so good results.
The 266/667 and 333/800 strap/dividers seem to give the best fsb/mem performance and overclockability ratio so perhaps you should try them.
I tried the same kit but with 2x512Mb and i got 600MHz CL4 on 2.75V on 4:5 strap 266/667:
http://www.xtremesystems.org/forums/...postcount=3910
2x1Gb kit because of higher density of mem chips will perhaps need more voltage so expect a bit more needed if you get near 600MHz CL4 on 2.75V as i did.
Hope it helps.