Nachthy & F.O.G.N.A.:QX9650@5735mhz, SPI 1M=8.110

[FiXeR]

That are some real nice results. Keep the good work up!

[k|ngp|n]

Nice first go guys. Next time for full LN2 3D, try to take everything down in temps and up in clocks in STEPS. Dont go for below -100c on everything right away until you know the exact limits of every piece of hardware in the system. Maybe run some benches at -50c first, then -80c, then below -100c.
You will use a little more LN2 this way, but in the long run you will gain a ton of knowledge about what each and every piece of hardware in the system is capable of and when you go do push everything all the way, you will be 100%prepared. Looking forward to your next bench session(s).

Good luck! and very cool dewar setup..

[nachthymnen]

Nice first go guys. Next time for full LN2 3D, try to take everything down in temps and up in clocks in STEPS. Dont go for below -100c on everything right away until you know the exact limits of every piece of hardware in the system. Maybe run some benches at -50c first, then -80c, then below -100c.
You will use a little more LN2 this way, but in the long run you will gain a ton of knowledge about what each and every piece of hardware in the system is capable of and when you go do push everything all the way, you will be 100%prepared. Looking forward to your next bench session(s).

Good luck! and very cool dewar setup..

Tks for your suggestions Vince
This time we know better the mainboard and also the right way to bench with a gpu under cold.
Last time we would like to find the cold bug and the vga in 15 minutes was completely frozen
For sure we will follow your instructions for tomorrow's session.

I'm curious to see @ what temp will be the cold bug of my Zotac 9800

Hope to do something's good tomorrow with the TEK9 (we can't fail again with the best pot for vga)
And soon also with the Dragon

@Fixer: tks