Phenom 9500 w/ MSI K9A2 Platinum

[batmang]

Great, but I am sure you can get more, you have one the lowest bin models I've come across - 1.2VID/1.2v 9600BE. It should be a better clocker than most others around, try below 2600 stock volts. Can it not go any further with unlocked multis?
Which BIOS are you on? What's your MEM rated for?
Try 212HTx11.5, don't change any voltages and check - it's a much better performance setting than what you're on and it looks like it should be stable at stock voltage. You are fine as long as you have sub 70C load temps in those utilities. That's well within rated spec, on the stock cooler, with no fan, I was reaching 55C load at just stock.

KTE, finally responding to ya. I'm running the stock heatsink and fan just to clarify. My memory setup is 4x1GB of G.Skill 6400 DDRII 800 (LINK). Bios I am using is 1.1 B3. I'm able to get up to 2.6GHz no problem within AOD but it eventually crashes. I even lowred the voltage to 1.18v and was able to run 3DMark06 at 2.6GHz but it eventually crashed. I'm not sure if my instability is my PSU's fault, I'm not sure how to measure that. The PSU is a generic 585w that came with my generic case. BTW, how do I adjust the multipler within the bios? Any other suggestions?