Rocketfish case aka Lian Li

[Jor3lBR]

I got mine at North Lake. Think they had 3 when I left.
As far a dremels go. Has any one tried the cutter that looks like a drill bit? It is the 561 MultiPurpose Cutting Bit. I have one and have thought abot trying it. Might be easier than a cutoff wheel.

It's a nice thing to elaborate more on how ppl are using the dremel and witch tool they are using...

Most of the courageous guys here are doing it by free hand... But I dunno If I would be so skillful with that thing at full rpm to make a perfect straight line... And the worst part is you only have 1 shot!

How about using a guided saw like this: http://www.dremel.com/en-us/attachme...=69679&I=69804

[Lu523]

Actually you would use a another attachment with the bit. http://www.dremel.com/en-us/attachme...=69679&I=69795
That would make it easier to use.

[iadstudio]

Actually you would use a another attachment with the bit. http://www.dremel.com/en-us/attachme...=69679&I=69795
That would make it easier to use.

I've tried that and those bits don't work so well on metal. If they made a carbide version it might work well.

[Jor3lBR]

Actually you would use a another attachment with the bit. http://www.dremel.com/en-us/attachme...=69679&I=69795
That would make it easier to use.

I was talking about another accessory. I really don't know how that tool in your link would help you make a straight line, but I bet that the thin case aluminum is easier to cut then that wood in the video preview.

I think this is the one your looking for:
678-01 Circle Cutter & Straight Edge Guide: http://www.dremel.com/en-us/attachme...=69679&I=69820