**Official DFI LanParty UT X48-T2R(and LT) Discussion

[Clunk]

I should point out that the voltages were measured by Jimmy @ DFI

[C-N]

I should point out that the voltages were measured by Jimmy @ DFI

I'd have him check again with 0320 BIOS & show us the measure points he used as my board hardly drops any voltage from BIOS set on the points I'm using. For the most part my board ever so slightly overvolts everything else.

CN

[JohnMike]

Something weird about my bandwith scores, Read should be the highest but in my case it's Write and Copy...

Anyone have seen this scores?!

[Dimek]

@JohnMike
The same here, but with a little lower FSB (445). Try to play with Performance Level


@Clunk
For 65nm chips it's GTL REF=67% of VTT.... What % is for 45nm chips :?:

[JohnMike]

@JohnMike
The same here, but with a little lower FSB (445). Try to play with Performance Level


@Clunk
For 65nm chips it's GTL REF=67% of VTT.... What % is for 45nm chips :?:

Same thing happens with others OC levels. Regarding Performance Level, seems to me that i can't manage a PL of 7 above 400 FSB, only 8 if i want to put it manual on bios.

It's hard for me to believe that this is as far as this board goes. With my ex-Maximus Formula SE i would get much higher OC and bandwith performance then i get know with DFI...

Why can't we make 1200mhz on Ram with 4GB?!...