Quote Originally Posted by PnoT View Post
If you are planning on RAID 0 which most of us use then any information on the current drive will be erased. All you have to do is hit CTRL I on boot to get into the raid manager and configure your drives/arrays

You'll also need to tell vista to install the raid drivers when it starts it's install and point it to the floppy or usb drive you have the drivers on.
Did you notice much difference in boot times with your Dual Raptor X config?

Any other improvements noticed?

I thought Vista is meant to remove need to have a floppy disk with drivers, as it comes with them within vista disk... i.e ready to go !

Hope so