Quote Originally Posted by WeldZilla View Post
DrSlump do not use spd or auto on memory.
Do it manually!!!

Set your mem to 1:1 and manually set the timings. If you are using 4 sticks of G.Skill 6400HZ then run the timings as tight as mine. Go no looser than 4-4-4-4 or 4-3-3-4 G.Skill HZ falls right on it's face when set to loose timings.
When you use SPD you get loose timings. DO NOT use SPD with this board!!


WZ
I can vouch for this also:

Running 333x9 With 2GB of G.Skill HZ I could run 1:1 (4-4-4-4) all the way up to 834Mhz. Then 4-4-4-12 above 834Mhz and finally 1000Mhz @ 5-5-5-15.

4GB will run 4-4-4-4 as far as 834Mhz and 4-4-4-12 above that. 1000Mhz @ 5-5-5-15 is not stable for me with 4GB.

SPD is not stable for me unless I run 1:1 and it gives me weird clocks like 3-7-5-10