**Official DFI LanParty UT X48-T2R(and LT) Discussion

[PnoT]

Hello

How far has anyone pushed memory speed with 2x2gb memory? I'm running Gskill 2x2gb ddr2 1066 and I can't seem to get anything over 1100mhz to run stable. Would 4x1gb modules have a better chance of being pushed more?

PnoT, did you ever get your mobo to work? I see you are running the same memory as i am, and i couldn't get the board to even post unless i set the NB voltage to about 1.35v. I'm running an e8400 cpu though.

Just a side note, I'm watercooling and I'm using this EK block on the NB and it works nicely:

http://www.frozencpu.com/products/66...?tl=g30c89s148

My board is posting again but it's very flaky on any type BIOS changes since it won't boot half the time. I also have to set my NB volts to about 1.34 to get things to run smoothly and I've got my ram at 5-5-5-15 @ 2.1v.

I fried my E3110 the other day, when i thought it was my board, so I've managed to get myself and E8400 now. I hope this cpu stabalizes better than the E3110. The second core on that thing would not run stable at 4ghz no matter what i did. What i find odd is that my boards is one of the few that has the cpu vid issue and when i fried the E3110 i had only put 1.36v into it and *poof*. That's an extremely low amount of volts to fry a chip and i can't help but think I need to RMA this board.