Testing Report: Gigabyte X48T-DQ6 Rev. 1.1

[BenchZowner]

What's the main difference between rev. 1.0 and 1.1 because i can buy the 1.0 here in the netherlands (mobo is only thing i need to finish my rig )

I'm not going into many details...but the major one is... fixed burnt mosfets issue when using high voltages

For the rest...I'll have to check with my contact in GB.

And i have 3 disks, 2x Raptors 74GB and 1x 36GB Raptor, if i would like to run Raid0 on the 74GB disks i want to use the ICH9 for it and should i use the ICH9 also for the single 36GB disk or is it better to use je JMicron next to the Raid0 on the ICH9?

You can use any configuration on the ICH9R.
And of course the one you've mentioned.
ICH9R > JMicron

U think 1,55 is too much? any idea what i can change coming back to 1,4125 and no getting crash?

Any idea on my thermal sensors problem?

Well, the inside of the CPU will always be hotter than the heatspreadder's edge... and the DTS signals are more trustworthy in this case.
You can try using lower Vcore to see if your CPU can work stably with less voltage.
Try 1.425V, and if it's unstable move on to 1.45V, and slowly to 1.475V ( if 1.45V is unstable again ).