Quote Originally Posted by Xilikon View Post
Thank you a lot for doing this testing. This helped me decide that I will stick to the stock top since it's not worth the expense (the pump will be used in a mosfets/chipset loop only so it's not a biggie with about 1.27 GPM from the estimator including the SF800).

To get the benefit of a aftermarket top while being able to tube in a restricted height situation, I would need to get a aftermarket top with top inlet and a good elbow.
I should probalby run one more test with some elbows mounted on the center inlet. I think a derlin elbow with a male to male fitting will do better than any of the side inlet setups.

That was a test case someone mentioned before I started all this testing anyhow. I need to work up a quick G1/4 coupler first and I'll test with a DD delrin 90. Maybe try a T experiment also...