**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[Ace-a-Rue]

Wow, 221 pages later I finally reach the end...

So I've got a 2140 while i wait on the 45nm quads to finally come visit. I've had this setup for about a month now and I've gotten it to 3.2ghz which is 400fsb. I'm not a total noob, but it IS my first time OC'ing an intel chipset, so I could use a little help plz.

My current settings are:
vcore 1.45
MCH 1.48
CPU VTT 1.35
ICH 1.32
DDR2 2.1
ICHIO 1.65

Now 3.2 is solid, nice and stable. But if i go to get to about 410 uguru locks my computer up. It won't apply without dieing. Have I reached the end of this chip, the fsbwall, or do i need to up the voltage somewhere? Temps are fine, cpu is hitting about 44 in orthos and pwm is about 48. This is vista x86 btw.

Thanks guys!

ICH is to high...you shouldn't need over 1.09, the max!

Vcore could be slightly higher

CPU VTT should be around 1.3v

MCH could be in the 1.5(x) range

ICHIO could be set to 1.7v

once you go over 1000 mhz overclock, you are just about getting to the maximum overclock especially if you are on air...some cpu's can go higher...i got about 1500 mhz on my Q6600 'G0' cpu...that is an exceptional cpu

[Imitation]

ICH is to high...you shouldn't need over 1.09, the max!

Vcore could be slightly higher

CPU VTT should be around 1.3v

MCH could be in the 1.5(x) range

ICHIO could be set to 1.7v

once you go over 1000 mhz overclock, you are just about getting to the maximum overclock especially if you are on air...some cpu's can go higher...i got about 1500 mhz on my Q6600 'G0' cpu...that is an exceptional cpu

Thanks Ace, I'm guessing its either the MCH or the ICHIO. I did lower the ICH. And considering its already at a 100% OC at 3.2 from 1.6 I'm pretty happy, but I always want more if there's more available!

This thread is awesome, as is this board so far.