Just posting new results on the E8400. I was able to achieve 3.4Ghz and I think it was stable. It survived 2 3DMark runs, and using Handbrake was able to encode Simpsons Movie to H.264 in 19 minutes. Total stressing lasted about 32 mins. Here are the settings used:

1510 FSB (377x9 = 3.4Ghz)
Ram at 755Mhz
Vcore at +0.25 (15 jumps) CPU-Z reported 1.38v
Ram at 2.10v
NB at 1.4

Anything but these setting resulted in no post. Did not have to modify the FSB Termination. During stress, CPU temp reached 33C, and idles at 26C. Case temp was 45-52C. Vid card idles at 60C (8800GTS 512). I have no way of reading the NB or SB temps but when I touched the rollercoaster fins I had to pull away within 3 seconds of being burned, SB I touch for 8 seconds before got too hot. During non OC state I can touch the SB indefinately and the NB for a good 20-30 seconds.

I was not able under any conditions to reach 3.6Ghz.

I am concerned about the beeps my mobo gives off during post. According to X-built`s research on this I am suffering from the following: 1 long, 2 short Failure in video system An error was encountered in the video BIOS ROM, or a horizontal retrace failure has been encountered. I don`t know what this means. I just got this rig less than a week ago, should I be calling the store that built it for warranty support? I would be greatful if someone could explain what this error code actually means.