Official DFI LanParty UT X38-T2R(and LT) Discussion/Review/Overclock/Guide Thread

[Ace-a-Rue]

I found a sticky on the DFI forums by Praz but... it's on the Q6600 processor and doesn't explain what's safe voltages etc..

i do believe there are no safe voltages above stock voltages.

[ReTiCuLeX]

Big sighs, I act like a noob and get treated like one.

I'm trying to figure out which NB Voltage I need to get 3.6ghz+ Also what other voltages need to be set etc..

I just tried 1.3vcore, 1.306 NB Voltage and relaxed all my memory with an instant BSOD still, when trying 3.6ghz =/.

[PhilDoc]

Big sighs, I act like a noob and get treated like one.

I'm trying to figure out which NB Voltage I need to get 3.6ghz+ Also what other voltages need to be set etc..

I just tried 1.3vcore, 1.306 NB Voltage and relaxed all my memory with an instant BSOD still, when trying 3.6ghz =/.

Wasn't trying to treat you that way. Make sure your memory is set to 1:1. Should be either 333/667 or 400/800. You may have to go higher with the vcore, but most e8400s would do 3.6 at 1.3v.

Also, make sure you disable the vdroop control.