2008 XS Cheapazchips 3D challenge

[Johnny Bravo]

BTW tested my mods finally and if you use two 10Kohm resistors the initial voltages are 2.0V for the memory and 1.35Volts for the GPU. If you'd rather have a lower starting voltage for the memory use a 50Kohm resistor but be aware that you're voltage control will be coarser the further up you go.

[zakelwe]

BTW tested my mods finally and if you use two 10Kohm resistors the initial voltages are 2.0V for the memory and 1.35Volts for the GPU. If you'd rather have a lower starting voltage for the memory use a 50Kohm resistor but be aware that you're voltage control will be coarser the further up you go.

Thanks for the update. I'm going to hazard a guess the Qimonda will not like too many volts so when I get around to do it then it will defo be closer to 10K.

I'm awaiting an Sli 780i board for some 8600GT testing today so I am not sure when I am going to be able to bench tjhe 8400Gs next, really I should do it first on the P5K board.

Regards

Andy