**Official DFI LanParty UT 790FX-M2R Review/Overclock/Guide Thread**

[KTE]

I think I asked before but it wasn't answered... has anyone with a Phenom and D9s been able to run plus 1200 RAM on this board?
What about >1200 4-4-4-4 (volts)?
What about 1200 5-5-5-x/4-4-4-x with >2.4G IMC? (EVEREST/Sandra/Pi)
What about 3-3-3-x >900-1100?
What about CAS4 1066 1T?

Has anyone been able to boot 1300 with RAM known to have done it easily?

The MSI RD790 has most of these limitations.

[Kennymester]

Have any of you gotten a hang error when waiting for the raid bios to scan your sata drives? I can't seem to enable raid on the new bios or the last one.

Thanks

[Iketh]

I think I asked before but it wasn't answered... has anyone with a Phenom and D9s been able to run plus 1200 RAM on this board?
What about >1200 4-4-4-4 (volts)?
What about 1200 5-5-5-x/4-4-4-x with >2.4G IMC? (EVEREST/Sandra/Pi)
What about 3-3-3-x >900-1100?
What about CAS4 1066 1T?

Has anyone been able to boot 1300 with RAM known to have done it easily?

The MSI RD790 has most of these limitations.

not with those timings... board defaults to crazy high 5-7-7-24 with my old ballistix that died for anything above 505mhz... still does it with 1/30/08 with d9gmh... i can manually bring it down to 5-5-5-16, but that's lowest.. and to revert back to lower timings, i have to reset cmos when running below 500mhz

[KTE]

not with those timings... board defaults to crazy high 5-7-7-24 with my old ballistix that died for anything above 505mhz... still does it with 1/30/08 with d9gmh... i can manually bring it down to 5-5-5-16, but that's lowest.. and to revert back to lower timings, i have to reset cmos when running below 500mhz

The 5-7-7-24 is default for all RAM which isn't JEDEC 1.8V 533MHz since the BIOS programmers specified high timings so you could boot that divider at even 1.8V and then once you get in you can manually lower the timings. MSI board does the same with Crucial D9s. However, the 5-5-5-16 is quite bad, that's the similar problem with MSI RD790. The lowest options it offers at 2.66 divider for both my RAMs is 4-5-5-15-12 which is not what I'm after since I've ran 2.3V 1352 5-5-5-5 with Intel chipsets only a week ago.

Thanks.