Quote Originally Posted by ChrissTi View Post
Rise MCH Voltage to 0.100, and then set mem strap to 2.4B, at the timings of your memory, also rise the mem voltage to what memory voltage is, and then rise the CPU voltage until works ok.
Cheers for the tip I'll give that a go in a short while.

I've just taken delivery of Twin2X4096-6400C5DHX memory which I was plannning on using when gaming in Vista, but can't yet get board to boot at all, the best it did was get to main default screen after BIOS reset with battery out, but that only lasted for a couple of seconds, then nothing happened just recycling boots.

Tried 1 stick at a time - no luck either - currently F7 BIOS not sure if its got problems with 2x2GB sticks, I thought there were some issues with 4x modules, but mine was fine with 4x 1GB XMS 6400 C4.

I'll try the memory in one of my other PCs and see if it works in that, once I've sorted this issue out it'll be time to start tweaking again with the Dominator memory.