Originally Posted by ChrissTi
I think you should check the temps in the new location, and if there isn't something that blocks the case ventilation holes. Or maybe there is some woodoo there.
temps up average 5 degrees from orignal location from ranges 54 -59 (old location ) to 59 -64 (new location) and would not overclock , had to lower the fsb a few notches AND lower the voltage of the cpu one notch!!. works o.k now tho .was very scary i tried everythng finaly the fsb , pheww. i must have been balancing on a knife edge at the most extream points of testing in the old location even tho i was at 9 hours primed. maybe that slight temp pushed it over the edge ..so new overclock setting were needed. oh well all's o.k now (touch skull). peace
Reply With Quote
Bookmarks