**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[SkItZo]

Since formatting and reinstalling windows, i am unable to change any settings using uguru, when i attempt to, my pc crashes and i get a static noise from my speakers. This happens when i am using Uguru 3.107. When i tried using Uguru 3.104 the program would crash before it loaded.I have tried uninstalling and reinstalling uguru several times all to no avail. It was working fine before i reinstalled windows, should i reformat and reinstall windows? (My specs are in my sig)

Thanks ace for the info
When i put it on the pwm`s do i just put a small drop on top of each so it does not leak over the edge of them when the HS is fitted? And should i use the MX2 on both NS and SB aswell as the PWM`s... And one last question for today atleast What bios should i flash to 14 or one of the beta ones???
Many Thanks Paul

The way i spread my MX-2 on my pwm sink was to spread it out on the sink itsself, i know people say to put a bit on each pwm, but i found that when i did it that way, it appeared that all pwms were making good contact with the sink, but when i spread it out on my sink it showed that the second last row of sinks was not making any contact at all. I would recomend using MX-2 for your nb and sb as it runs 3 or so degrees cooler than ceramique. I have found that it even competes with Shin Etsu X23. I personally would reccomend flashing to the beta bios 16 with the method that Ace-A-Rue has posted.