**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[cantankerous]

That's the only screen I saw issues with. GTL+ Buffers Strength should be showing Strong as the selection. Next line down would be Host Slew Rate and that should be displaying weak. These are both default settings and are set correctly even thought they can't be seen. The plus if there is one is that rarely do either of these need to be changed. But if the need does arise the change can be made.

No need to change the jumpers for FSB. The same applies to Clock VCO Divider in the BIOS. These two must be set to agree with each other. Their only real purpose comes into play if the system is going to be run at stock speeds only.

Weird, I never got the glitch on that exact screen, I was always getting it under the memory timings page. I wasn't able to change the first to options to 'Fast' because of this so exited and flashed back to 12/24.

[Praz]

Weird, I never got the glitch on that exact screen, I was always getting it under the memory timings page. I wasn't able to change the first to options to 'Fast' because of this so exited and flashed back to 12/24.

Displays fine on my board.

[politenessman]

just a heads up - the tr ultima 90 fits on this board in the vertical position (unlike the ultra 120), but it reaches the absolute top of the board, even higher with the clips. and it actually cools a little better than the ultra 120, 1-2c idle, 2-3c load, using same fan, vcore, etc. but this could be because of the correct (?) orientation of the hs.

[mad_skills]

The test on anand shows well how the board works with stock and o/c-ed mem. dividers, perhaps someone will find it useful, i know i did:
http://www.anandtech.com/mb/showdoc.aspx?i=3129&p=1 .

[soundx98]

Hale of a good job by Raja/Raju on that.
very nice read.

[mad_skills]

Yes, i really both liked it and found it useful, nice review. Covered all areas nicely, i didn't know some thing i read there and later did some fine tweaking with them..