i just got my IP35 Pro and did the bolt mod. Its now installed and formatting. However i had problems getting it to post with all 4Gb of my memory in it. It would either hang at the C1 or C5 code and refuse to post with 4X1Gb. I upped the voltage to 2.1v for the memory but that didnt help. Is this a bios issue or a setting that needs to be changed?
7820X | Asrock X299 Taichi XE | Gigabyte 1080 Ti Xtreme | 32GB Memoriez | Corsair HXi1000 | 500GB 960 Evo
Try to loosen TRFC. I had the same problem. Make sure your other timings aren't too tight aswell.Originally Posted by Budwise
finally got it to boot with 4Gb by raising the NB to 1.65v and MCH to 1.41v.
7820X | Asrock X299 Taichi XE | Gigabyte 1080 Ti Xtreme | 32GB Memoriez | Corsair HXi1000 | 500GB 960 Evo
wait wha...???? You mean Vcore to 1.65V and MCH aka NB to 1.41?finally got it to boot with 4Gb by raising the NB to 1.65v and MCH to 1.41v.
Core
Core i7 920
eVGA X58 LE SLi
2x3GB Mushkin DDR3-1600
BFG 8800GT OC
Seagate 7200.12 1TB + Maxtor 320GB
LianLi A05B
Cooling (all internal)
2x BI GTS 360
2x DDC3.2 + Ek top
EK Supreme LT
you meant to say SB or ICHIO 1.5 to 1.65v...right!finally got it to boot with 4Gb by raising the NB to 1.65v and MCH to 1.41v.
there is no NB voltage to set on this board.
BIOSTAR TPOWER I45 UNOFFICIAL THREAD
BIOSTAR TPOWER BOLT MOD FOR HEATPIPE AND HEATSINK
BIOSTAR TPOWER I45 BIOS FLASHING PROCEDURE
ABIT IP35 PRO HEATPIPE MOD
ABIT IP35 PRO BIOS FLASHING PROCEDURE
IP35 Pro: 9650@4000Mhz, par overclocker; Freezone Elite; 4Gb GSkill DDR-800@DDR-1068 (2 x 2gb); XFX 8800 GTS; Areca 8X PCIe in Raid 0 working at 4x speed; 4-250 Gb (single platter) 7200.10 drives; Giga 3DAurora case with side window.
Posting Permissions
Reply With Quote
Bookmarks