[MemoryReaction] G.Skill F2-8000CL5D-4GBPQ - Low in cost, high in speed!

[Praz]

How many people here are running this in conjunction with a quad (q6600 most likely)? Most of the people reporting including EnJoY seem to be running these with dual cores and chips that require higher FSB (allendale). I've noticed myselff that even getting back what I used to run 420x9, seems to be difficult in the stability department for my quad or ram or something else.

Haven't found the top end for the ram yet.

[EnJoY]

I just bought these for my IP35 Pro Mainboard. I opted for the 2x2GB DDR 1000 Chips.

I'm experiencing an issue though.

When I use both chips in Dimm Slots A. The system will post and boot up fine.

When I try use Dual Channel I.E - use one chip in Dimm Slot A and One in Dimm Slot B. The sytem will not post. The mainboard gives me an error code of C1.

I have selected the correct voltage in the BIOS but still this doesnt resolve my issue.

I had the same issue with some Corsair DDR2 PC6400 RAM. I don't think its the RAM.

Is this issue happening because there are too many issues when attempting to use all 4 slots or one of each?

I need to know if my board is faulty.

Please advise.

I've responded to your PM. I gave you a few suggestions on some small things to try, but overall, unfortunately it seems you may have a faulty motherboard as I have yet to experience such an issue with any bios and/or memory configuration in this board.

Haven't found the top end for the ram yet.

Nice work!

[Praz]

Nice work!

It's the memory that deserves the credit. I'm just along for the ride. If they continues to scale and not just hit a wall there should be still more left. The voltage is at 2.1 but I'm not even sure that much is needed right now. With tRP currently at 3 and some of the secondaries on the tight side there's still some hope for improvement. Even PL is misleading being shown at 8. 9 of the 10 phases are pulled in so it's almost at 7 flat. And then there's all the channel and clock crossing settings that I haven't even touched yet.

[Cronos]

And then there's all the channel and clock crossing settings that I haven't even touched yet.

You'd better start from your testing technique.