**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[emoners]

I don't like the sound of the 430w PSU or the fact its an Enermax have you a different larger one you can try on it?

Are you using the auxiliary 12v & floppy connectors ? (they help high fsb for me)

GTL+ Buffer strength & Host slew rate have never stopped my board booting but NB GTL has, when I push my boards fsb up high the NB GTL makes all the difference as to what will boot/run & be stable enough to bench.

I also need just about all the vNB my board has for 2.7~2.8vdimm to run PI 32M

I am nobody to judge anybody but 3v to the RAM is suicidal they will die I hope you can accept this & you know what you are doing (no offence intended)

CN

something like this bro?


from Praz: http://www.xtremesystems.org/forums/...&postcount=872

how does it work?

[C-N]

something like this bro?

http://www.edgeofstability.com/images/y_connector.jpg
from Praz: http://www.xtremesystems.org/forums/...&postcount=872

how does it work?

All I meant was have you got the No:1 floppy connector & No2: 2 x 4 pin 12v sockets powered up as IMO it helps high fsb.

My PSU has all the connectors on it so I don't need the splitter.

CN

[emoners]

All I meant was have you got the No:1 floppy connector & No2: 2 x 4 pin 12v sockets powered up as IMO it helps high fsb.

My PSU has all the connectors on it so I don't need the splitter.

CN

oh...i didn't use the floppy connector since i thought i wasn't using a floppy drive (& totally mess up the cable management), but i did put on the 2x 4-pin 12v. so is it advisable to put on the floppy connector? Thanks for the reply C-N!

[C-N]

oh...i didn't use the floppy connector since i thought i wasn't using a floppy drive (& totally mess up the cable management), but i did put on the 2x 4-pin 12v. so is it advisable to put on the floppy connector? Thanks for the reply C-N!

Ever since I got an extra 5-10fsb out of my 975X/G pluging in everything it had I have just made it a habit to plug everything in & I have never been disappointed.

I cant remember where I seen it (probably DFI/DIY Street or DFI Club) but as far as I can remember plugging in the 2 x 12v's are highly recommended & plugging in the floppy is recommended if using a high end card.

Maybe Praz would be able to give us the official line on this ?

CN