Official DFI LanParty UT X38-T2R(and LT) Discussion/Review/Overclock/Guide Thread

[Ace-a-Rue]

I don't have the faintest idea why the Reloaded settings would have appeared to be gone after clearing the CMOS. The fact that your settings reappeared is what should always happen. The Reloaded settings are not stored in the BIOS chip. The utility required to wipe those settings is not available to the public. Once settings are stored the only thing the user can do is overwrite them.

but those settings were gone after resetting the 2 jumpers back to normal...they didn't come back until after i got the memory out of tolerance beeps...my reloaded settings were all gone...everything was blank and suddenly they are there after powering down from the beeping memory out of tolerance sound.

tell me what the RTC is for on page 16 of the manual...it is right next (parallel) to the CMOS jumper...it reads like it resets those settings when the battery is out and jumper set just like you are clearing the cmos.

strange, very strange, WEIRD board!...could be the QX9650 causing it to act weird...the DTS temp readouts are defective, IMO...going to take a $200 hit to replace the CPU with clubit.com...the reason for the $200 hit is that i recycled the packaging...darn!...wish i wasn't so green!

EDIT:...thought you should know that intel won't honor their warranty when it comes to DTS readings...this tech support guy said, don't worry about the temps...no need to track them if you overheat...the board will shutdown automatically once it receives the signal from the processor...DO YOU BELIEVE THAT!