**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[Panthols]

Is there any decent aftermarket PWM heatsinks for this board, or any way to mod something existing to fit? I'm putting the NB and SB on water shortly after christmas and I didn't feel like cutting up or baking the stock solution.

[Nosfer@tu]

Is there any decent aftermarket PWM heatsinks for this board, or any way to mod something existing to fit? I'm putting the NB and SB on water shortly after christmas and I didn't feel like cutting up or baking the stock solution.

There is a mod, Look a Ace signature for link = its free and DOI

[Heidfirst]

Is there any decent aftermarket PWM heatsinks for this board, or any way to mod something existing to fit? I'm putting the NB and SB on water shortly after christmas and I didn't feel like cutting up or baking the stock solution.

there are a couple of mosfet blocks from European manufacturers.

[myerz635]

Is there any decent aftermarket PWM heatsinks for this board, or any way to mod something existing to fit? I'm putting the NB and SB on water shortly after christmas and I didn't feel like cutting up or baking the stock solution.

I just used swiftech ramsinks with a 70mm fan blowing over them....33C idle 51C prime load. Don't waste your time w/c the SB....it doesnt get hot enough, im using a passive enzotech copper heatsink on mine and its barely warm I have my NB w/c but im realizing that its also a waste and adding unecessary heat to my loop so i will be removing it when i get my 8800 GT