Guys, I'm experiencing some temperature problems with my board... with 1,6V NB and my SB voltage set to auto, my temperature are respectively 45 degrees for the northbrige and 40-42 for the southbridge...

Today I decided to remove the heatsink to clean the old paste (or should I say glue) and I even lapped a little bit bot the north and the southbridge copper sink and I applied some MX-2 and the temperature did not change!

I'm really pissed... to remove the old paste I had to lap a little bit the north bridge so I voided my warrenty and my temps keep still sucks

Any clue?

BTW I'm using the NON-SE version...