Official GIGABYTE X38-DQ6/X38T-DQ6 Info/BIOS Thread

[freqy]

waku waku wrote>>yesterday i wanted to change some Volt settings and after that my overclock settings didnt want to pick up by the board.Whatever i do it stays on default, even though the bios tells me i am running 9x400.

its early in the morning for me..so i'm not sure i totally understand..
are you saying no matter what you do, if you leave everything at stock values ..it reverts back to auto after you reboot??

does the system reboot.. then go off... then reboot again? if that happens the bios will switch back to auto.

there will be a problem with the motherboard reconising your components stock settings perhaps??

post your intelligent tweaker settings maybe we can help further.??

the jumper thing should work ...damn what a pain....are you sure your jumper is touching the pins o.k?

sorrry if i seem all mesed up with typing ...i havent slept for over 30hrs....ive been trying to fix a software problem...i finally did it ...but it wasnt much fun.

peace