New EK CPU block!!

[Malik]

I'm confused Malik...in your earlier post, you were comparing a BOWED dtek's flow rate to the Supreme...

in the 2nd, you switched to a non-bowed, non-nozzled?

Sorry for that - i have wrong info.

Now is all ok and here are all results: LINK

[jarogniew]

Sorry for that - i have wrong info.

Now is all ok and here are all results: LINK

for sure

numbers in that link are delta T water temp/cpu

Dtek is new from box, non-bowed non-nozzled

ttested on E6750 @ 3800MHz @ 1,45V

stressed with orthos for 30minutes, temp measure with coretemp

wc setup: BWA123UV (magicool 360mm uv radiator), swiftech MCP655, swiftech MCRES-Micro Res, tubes 10mm/14mm and Swissflow sf800
water temp was measure with TES 1314

thermal compound: AS5

each block was mount 4 times and on chart is best mount only


ps. sry for my poor english

[RLM]

Not necessarily questioning these findings, but would like to see some other people's results as well.

If I'm to put my results against these results, then the non bowed without nozzles fuzion is also quite a bit better than the GTX as well.

RLM

[Navanod]

Sorry for that - i have wrong info.

Now is all ok and here are all results: LINK

Thanks for the clarification...sadly, i'm not able to understand most of it...still, the charts spoke for themselves.
very interesting...

[Martinm210]

Sorry for that - i have wrong info.

Now is all ok and here are all results: LINK

Thanks for posting

[jammin]

i hope the supreme fits on the foxconn mars!