ók guys i got my multimeter back, i check my stock voltages and core was 1.32 and mem is a high 2.2volts, so i got a 1k VR and did the mod, i set my volts to 1.4 and under load it dropped back to 1.35...so i adjusted it under load to 1.42 volts but idle is 1.49...should i worry? i ran 3dmark2006 and got a nice 16376.
Andrew
DFI LTx48t2r:q9650@4ghz:4xOCZ9600FLEX:ATI 3X4870 CFX 840/1100:BFG PHYSX CARD:2x74g RAPTOR RAID 0: DELL 30"+2x2001FP":Corsair hx1000: D800:Logitech G15,G9&Z5500
did you mod the resistor shown in the pic above, or did you use the normal one??Originally Posted by terroristone
I need to confirm if the spot shown in the picture above actely works as an alternative mod spot? Course i actely spiked 2.5v Vgpu through my ultra card today, and almost killed it, using that point. But if someone can confirm that spot actely works, i most have done something wrong, and will try again.
Last edited by SIOUX; 12-12-2007 at 05:50 PM.
The whole world's hip and thats not cool !
Rip Van Hippy
Doesn't expecting the unexpected make the unexpected the expected ?
Light travels faster than sound. This is why some people appear bright until you hear them speak
-------------------------
Dont adjust under load! Do it while idling. Yes the drop in voltage is normal. Max voltage i'd play with is 1.6v under water.. usually any more you'll need serious cooling and a another mod to stop the card from shutting down with that much voltage.
Running now, http://www.evga.com/forums/tm.aspx?m=693435
Intel 3960 @ 5Ghz
Asus Rampage IV Extreme
QuadFire 7970
X-Fi Sound Card
16GB G.Skill 2133Mhz DDR3 Quad Channel Ram 9,11,10 @ 1.65v.
3 Acer 23" 3D Ready LCDs
2x Ultra X4 1600 WATT P/S 's
MM Extension Ascention UFO Case W/ Top of the line Water cooling. Dream build!
Posting Permissions
Reply With Quote
Bookmarks