What happened to your reply Tim?
I read it last night, was going to reread it again today, and now its gone?
What happened to your reply Tim?
I read it last night, was going to reread it again today, and now its gone?
TY.
All taken care of![]()
ók guys i got my multimeter back, i check my stock voltages and core was 1.32 and mem is a high 2.2volts, so i got a 1k VR and did the mod, i set my volts to 1.4 and under load it dropped back to 1.35...so i adjusted it under load to 1.42 volts but idle is 1.49...should i worry? i ran 3dmark2006 and got a nice 16376.
Andrew
DFI LTx48t2r:q9650@4ghz:4xOCZ9600FLEX:ATI 3X4870 CFX 840/1100:BFG PHYSX CARD:2x74g RAPTOR RAID 0: DELL 30"+2x2001FP":Corsair hx1000: D800:Logitech G15,G9&Z5500
did you mod the resistor shown in the pic above, or did you use the normal one??
I need to confirm if the spot shown in the picture above actely works as an alternative mod spot? Course i actely spiked 2.5v Vgpu through my ultra card today, and almost killed it, using that point. But if someone can confirm that spot actely works, i most have done something wrong, and will try again.
Last edited by SIOUX; 12-12-2007 at 05:50 PM.
The whole world's hip and thats not cool !
Rip Van Hippy
Doesn't expecting the unexpected make the unexpected the expected ?
Light travels faster than sound. This is why some people appear bright until you hear them speak
-------------------------
Running now, http://www.evga.com/forums/tm.aspx?m=693435
Intel 3960 @ 5Ghz
Asus Rampage IV Extreme
QuadFire 7970
X-Fi Sound Card
16GB G.Skill 2133Mhz DDR3 Quad Channel Ram 9,11,10 @ 1.65v.
3 Acer 23" 3D Ready LCDs
2x Ultra X4 1600 WATT P/S 's
MM Extension Ascention UFO Case W/ Top of the line Water cooling. Dream build!
Bookmarks