ATI 3850/3870 Voltmod thread

[K404]

dude...VMem mod is DONE the only thing missing is the ideal pot value.

Someone should take the initiative and friggin TRY it.

Start with 100K....tune down until it bites then measure the resistance.

Jeeezzzzzz

AFI...I know you KNOW this!

[/exasperation]

[pepinorang]

dude...VMem mod is DONE the only thing missing is the ideal pot value.

Someone should take the initiative and friggin TRY it.

Start with 100K....tune down until it bites then measure the resistance.

Jeeezzzzzz

AFI...I know you KNOW this!

[/exasperation]

I'm on HD3870 (one card 930/1340 and the other 902/1340 ALL stock) I'm just awaiting EK waterblocks and trimmers to do both mods don't worry about it I'm adventurous so I take the initiative will give my feedback here next week I think

Bye
p€p|n0r@ng

[kemist]

I'm on HD3870 (one card 930/1340 and the other 902/1340 ALL stock) I'm just awaiting EK waterblocks and trimmers to do both mods don't worry about it I'm adventurous so I take the initiative will give my feedback here next week I think

Bye
p€p|n0r@ng

What are you using to clock the cores? Atitool doesnt work, rivatuner works, but only for one core (for me at least), and ati tray tools didnt appear to work.

Ahh ok, was using ati tool .27 B3, will give it a try when i get home, thanks.

[JamesBong420]

atitool .27 b4 works for me. 3850

http://www.techpowerup.com/wizzard/ATITool_0.27b4.exe

[chp]

atitool .27 b4 works for me. 3850

http://www.techpowerup.com/wizzard/ATITool_0.27b4.exe

It Works???

Everytime I try to apply the new values (0.27b3 or 0.27b4) the system crashes. I have a Connect3D 3850 512MB.

It work only if I use it in conjunction with RT 206, not alone.

Else, Someone has the resulting values from the 100K VR?

[JamesBong420]

yup it works for me. make sure you have "if card has 2d 3d clocks,switch to 3d..." is checked and suspend while ATItool is running resume on quit. in the HD 2000 overclocking section. which is in settings. i know dont make any sense but i hope that helps..

[chp]

Unfortunately it doesn't.

Could it be a conflict with CCC?
Perhaps I missed something?

[pepinorang]

What are you using to clock the cores? Atitool doesnt work, rivatuner works, but only for one core (for me at least), and ati tray tools didnt appear to work.

Ahh ok, was using ati tool .27 B3, will give it a try when i get home, thanks.

Rivatuner works properly for me but there is a "procedure" to follow if you want to clock CF but for me now it's bios-modded

[kemist]

Quick question.

Would it be bad if i were to bridge these two points with solder? It looks like the are connected by the pcb and so it wouldnt matter if the were bridged?

[largon]

Quick question.

Would it be bad if i were to bridge these two points with solder? It looks like the are connected by the pcb and so it wouldnt matter if the were bridged?

You can do that.
These points are connected via PCB trace already.