Anyone tried using the mosfet WBs on other boards? I am wondering if any of them could be made to work on an Abit P35 mobo.
Anyone tried using the mosfet WBs on other boards? I am wondering if any of them could be made to work on an Abit P35 mobo.
Would this fits on Maximus Formula? This is 16mm width vs EK 17mm width, correct?
http://www.koolance.com/water-coolin...roducts_id=433
Last edited by mildseven7; 10-18-2007 at 06:51 PM.
[SYSTEM]TT Mozart XT - Maximus Formula - E6850 - 8800Ultra - DDR2 1066 x 4 - SAS 15K x4 Raid0(Adaptec3805) - Zalman ZM850 - Apple 30" LCD
[Monitor]BigNG + MiniNg
Loop1(3/8): DDC+3.2(Petra Top) -> PA120.3 -> Enzotech SCW-1 -> DD 8800GTX Block -> EK-RES250
Loop2(1/4): DDC+3.2(Petra Top) -> PA120.2 -> MIPS RAM Freezer4 -> Asus fusion chipsets block -> Silentstar HD Block x 3-> Pumps cooled by Alphacool HDD3CU/Plexi 3.5" HD Block -> EK-RES250
Before putting the cooler on the NB did you replace the heat spreader?, I have the exact same issue where th heat spreader came off, the chip appears fine however. (Damn hard glue they use on the NB).
What do you suggest Pete?
Thanks,
ERIC
Had a quick chat with are lad Eddy EK...Originally Posted by Eddy_EK
I need only the holde distances for NB.
For mosfets we need only to take away that bump...
In production...
EK-Mosfet ASUS 3a (X38)
http://ekwaterblocks.com/shop/index.php?cPath=21_48 (bottom of the page)
Mosfet ASUS 3a water blocks supports following motherboards:
Especially X38 chipset ASUS motherboards and also:
P5K,
P5W,
A8N,
A8N 32,
P5B,
P5K3,
5N32,
Commando,
Striker,
Striker Extreme
Whats really good is they are same price as the ASUS EK 3 blocks.
Hopefull with a Chilled PC mosfet backplate these will do a much better job at cooling my mosfets that are getting uber hot
I have question about blocks for this mobo: Swiftech MCW30 will be match for nb, sb on this asus ?
How can the new Asus 3a block work effectively on a Striker, P5n32 (plus)?
I have the older EK Mosfet blocks with the four fingers protruding out the side to catch the MOSFET chips between some board components. This does not seem that it would not even touch those "hard to reach" ones. See picture:
http://www.xtremesystems.org/forums/...1&d=1181006166
Get a Maxiumius formular then see the proble i took plent of Photos even Eddy saw the issues
Posting Permissions
Reply With Quote
Bookmarks