**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[georgesod]

U-guru doesn't work for me. Any suggestions? Bios 14

[georgesod]

U-guru doesn't work for me. Any suggestions? Bios 14

Any help here?

[AstroCreep]

Any help here?

Well, first and foremost, did you uninstall, reboot, then reinstall? (May not hurt to re-download it just to make sure your install isn't corrupt.)
If not, try it.

If so, uninstall, reboot, set BIOS defaults, and reinstall it again.

I haven't had any issues with uGuru myself, but these are the steps I'd try.

Good luck!

[georgesod]

Well, first and foremost, did you uninstall, reboot, then reinstall? (May not hurt to re-download it just to make sure your install isn't corrupt.)
If not, try it.

If so, uninstall, reboot, set BIOS defaults, and reinstall it again.

I haven't had any issues with uGuru myself, but these are the steps I'd try.

Good luck!

I've already done that thank's

[atlr]

Hope this helps. uguru v1.04 downloaded from the abit website does not work with the IP35 Pro rev 1.1 bios 14 I have. uguru v1.05 included on the CD that came with the motherboard does run although CPU temperature is about 15 degrees less than what the utility coretemp v0.95.4 shows.

[Ravynmagi]

Hope this helps. uguru v1.04 downloaded from the abit website does not work with the IP35 Pro rev 1.1 bios 14 I have. uguru v1.05 included on the CD that came with the motherboard does run although CPU temperature is about 15 degrees less than what the utility coretemp v0.95.4 shows.

Me too. Version I downloaded would keep crashing. My good friend Mr Internet suggested I use the CD version instead. That know it all bastard was right again.

[phu]

I had another issue where my cpu fan always run at full speed. I tried to clear the cmos to see if that fixes the issue. Now when I look at the CPU VTT values there are only 2.0 and 2.3. Before I cleared the cmos, there was 2.0, 2.3, and 2.7. Does anyone know how I can get back the 2.7 value? Thanks.