Quote Originally Posted by Renegade5399 View Post
OK, I am highly suggesting plumbing the Fusion block into your loop if you can. Dropped NB temp from 47°C to 34°C under load. NB volts at 1.65. It also helps anything on the heatpipe lose a degree or two, my SB temp is down some too. It didn't kill my flow too bad, dropped it some, but not bad. All I had was a CPU block in the loop anyways. And the MCP655 has a lot of push power.
I haven't tried without the fusion block, but i have the same temps with it connected. 33°C idle, 36°C load on NB. Around 32°C both idle/load on SB. ~1,65v on NB.

I have a SB X-Fi Gamer card in my last PCI port and i've got no problems at all with it.

Run my Q6600 on 3,8ghz (423*9) 1,5v vcore 100% Stable

btw. Best board i've ever owned for overclocking