Freeze Pack Controller

[gsmaster]

Hori the link you posted is for the LM335 series not for the LM35 they are different.

Here is the manufacturers product page http://www.national.com/mpf/LM/LM35.html
You need the LM35 in a TO-92 casing. The letters behind the label LM35xx are just different models with different accuracy and other characteristics and of course different price.
LM35DZ, the cheapest one will work fine.

Any other casing (except TO-92) of LM35 will work but the size and shape of the sensor does not help for proper installation.

Try to re-solder the sensor, and run it for some hours, it might work.

[HoriWanderFuLL]

Thanks mate for the correct info..when i was rying to remove the wire sleeving and as i was moving it i could see temp reading up to where it should be and i was wigling it and it broke it close to the sensor ..So i will just buy a new sensor.

[HoriWanderFuLL]

Ok all i need to know is ground/pin Vout/pin and Vs/pin on the controller and i can wire to the new sensor..

i used a multi meter on the controller i have left pin 5v middle pin 0v right pin .062v this is looking at the controller from the front being temp pins 1st from the left.

Please wake up Greece must be breaky time by now :-)