e6550 and biostar p35 dice ocin 56k warning

[natedog420]

had a few test and didnt do to bad for my first time. had to stop do to condensation need more insulation. but was a good start had lots of fun doing this and learned how to make a nice mixture. saw -80c at 1.4 vcore but i dont think i got a pic of that. but ill let the pics do the talkin. super pi was not optimized and had better runs than the one in the video. uploading on youtube as i type will edit and add it as soon as its done. lata

edit: cpu liked 1.82 to 1.87. i tried higher and it didnt like it. think it needs ln2 for higher vcore.

http://valid.x86-secret.com/show_oc.php?id=259881

video is working now here it is. just quick super pi not optimized.

http://www.youtube.com/watch?v=whnVc_x9IGw

the super pi in the video had a little hiccup between the 7 to 8th calculation. dont know why maybe it tried crashing dunno. but had almost 13s flat before that. so not sure. speedfan would read below 9c. maybe due to condensation to dunno.

[natedog420]

more pics

[natedog420]

more pics

more pics

[natedog420]

more pics last ones will post video very soon when its done

[natedog420]

forgot about these pics lol

UPDATED first post with verification and youtube video

[[XC] gomeler]

Nice FSB on those runs, crazy vcore for sub-4GHz though Glad to see the ghetto pop works

[TiN_]

I like that green type of insulation, what is it? :-D
I've also got 3902MHz CPU-Z today, but with SS DIY phase (-40C).
These E6550 are trash, like E6600 benching much more (4.5GHz stable same phase)

[natedog420]

thanks yes there not the greatest but its fun. the pot worked very well actually saw better temps than i thought i would. didn think i would see -80 c or even close. didnt try max fsb cuz of condensation. i actually am not done i didnt max it out yet becuz of having to stop. so i will be runnin again hopefully next week sometime. video is up now and working updated first post check it out.

edit: reason for condensation is i didnt insulate the bottom of the board. i forgot i was in a hurry to bench and didnt think of it. so next time i will have insulation on the bottom of the board. there was actually water dripping off the ends of the main cpu coils on the bottom of the board. lol sub cooling is great i might get a few liters of ln2 next time to try that. i think if i bench for 30 minutes with ln2 i would be fine. but who knows. the pot held up really great for being a 10 dollar pot lmao. well look forward to seeing more benchs from me with sub cooling hehe. you think the solder will hold ln2. it was fine with -80c and so on. no leaks or anything. had a few boil overs but figured out how to not have them by adding more dice to the mix and having the pot always full of dice.