I know this is going slightly off topic but if anyone could point me in the right direction I would appreciate it.

I have been using a Thermaltake Ultra 120 Xtreme for a little while now on various boards with good results. last night I switched back from water to air & am now having problems getting a good seat to the CPU.

My problem is the xtreme's mounting hardware is not applying enough clamp pressure on the CPU & the heatsink therefore is loose & resulting in poor contact with the CPU.

I have temporarily used the mounting bolts & springs from my D-Tek waterblock to re-fit the Xtreme & last night run prime @ 3.8GHz on the 913 BIOS & all went fine however I want to use my D-Tek block on something else & need the mounting bolts back.

Is anyone else having problems with the TRUE & if so how have you got round it.

Does anyone know if the older Ultra 120's bracket will fit between the heatpipes on the Xtreme & therefore allow me to use the older more substantial bracket if I can find one.

Finally does anyone know where I can buy a replacement mounting kit for the TRUE in the UK

CN.